How To Make A Story Pole For Siding

How To Make A Story Pole For Siding. (see “making a story pole.”) hold the top of the story pole snug against the frieze board and mark out the siding courses (photo 6) at all corners and around windows and doors. With a utility knife, notch the top of the board to fit beneath the window.

Pin on Build it from www.pinterest.ca

A story pole is a homemade measuring rod on which the only markings are ones you make yourself. Pressure washer just doesn't get the crud, need the brushing action to get really clean! Getting soap up there is also a pain, have tried every conceivable.

Source: www.pinterest.com

Take the storypole and place it on the wall making sure it is plumb, place a tick make on thewall that corresponds to a mark on the pole, level a line around as required,take your story pole and place it on the wall lining up with the original markand transfer all marks from the pole to the wall, if you do this at the cornerssnap a chalk line at each mark and you are done. (save the scrap for step 9.) step 7 fit siding around windows

Source: www.pinterest.ca

These marks are then transferred to the wall, where chalk lines are then struck. Pressure washer just doesn't get the crud, need the brushing action to get really clean!

Source: www.youtube.com

Nail the clapboard to the studs as in step 3. 2 use pitchfork to remove all damaged shingles from house.

Source: www.pinterest.com

Mark locations of shingle courses on pole. (save the scrap for step 9.) step 7 fit siding around windows

Source: www.pinterest.com

Many professionals will use this starter board and story pole over and over, instead of striking chalk lines as the chalk may permanently stain the wood. With a utility knife, notch the top of the board to fit beneath the window.

With The Trim Boards Completed, Lay Out The Siding Courses With A Story Pole.

Getting soap up there is also a pain, have tried every conceivable. Along this story pole will be a series of marks indicating the exact reveal required by the plans. Based on the window reference points, i can make story poles for the upper levels, gables, or additions.

2 Use Pitchfork To Remove All Damaged Shingles From House.

Four inches of foam was added to the outside of the walls, and it was held in place with furring strips. Brought to you by weyerhaeuser dis. Make a story pole from a straight 1x3;

Many Professionals Will Use This Starter Board And Story Pole Over And Over, Instead Of Striking Chalk Lines As The Chalk May Permanently Stain The Wood.

3 peel off any paper or housewrap; A story pole is a homemade measuring rod on which the only markings are ones you make yourself. How to install clapboard siding.

Again Using The Story Pole, Mark The Trim Pieces Around Windows And Doors.

Bend flashing over the water table so it extends 1 inch up the wall. Be sure to hold the pole at the exact same height every time you mark trim boards. Because foam compresses, before installing any siding, you have to align the furring strips into a flat plane.

Follow The Chalk Line To Align The Butts.

Determine the desired “reveal”—the vertical width of the boards that will be exposed. Mark locations of shingle courses on pole. This trick also comes in handy for figuring siding exposure above and below the windows.